A standard 22-inch kettle can hold 225 to 275°F for most of a working day on a single load of briquettes, without a single refuel, if you arrange the coals as a snake. Weber’s own setup guide for its 57 cm kettle puts the method at up to 8 to 12 hours of low-and-slow cooking. The trick is that only a few briquettes burn at any moment, lighting their neighbours one by one along a curved line. This guide gives the layout, a briquette count matched to cook length, where the wood and water go, how to set the vents, and how to fix a snake that runs too hot or goes out.
How the Snake Works in Plain Terms
On a normal fire, every coal is lit at once, so heat peaks fast and fades. A snake is a fuse. You light one end, and the burn creeps along the line at a steady rate. Because the lit section stays small, the temperature stays low and even, and the kettle behaves like a smoker.
The same idea runs through every charcoal low-and-slow method. What differs is the shape. The ring around the edge of a kettle leaves the middle free for a water pan and the food.
Building the Snake, Step by Step
This layout follows Weber’s snake method setup for the 57 cm kettle, with practical notes added.
- Open both vents and take the lid off. Clear old ash from the bottom so air can reach the fire.
- Lay the base rows. Set two rows of briquettes side by side around the outside of the charcoal grate, leaning against the kettle wall, covering about half the circumference.
- Add a top row if you need a long cook. Many cooks stack a third row on top of the two base rows, making a 2-and-1 pyramid that burns longer.
- Place the wood. Put two or three fist-sized wood chunks on top of the snake near the starting end, spaced a few centimetres apart, so smoke comes during the first hours when the meat takes it best.
- Light 8 to 10 briquettes in a chimney or in a corner away from the snake. When fully ashed over, set them at one end of the snake, touching the unlit coals.
- Set the water pan in the open centre of the charcoal grate and fill it with warm water.
- Grate on, lid on, wait. Give it 10 to 15 minutes to settle, then adjust the top vent.
If you have never used a chimney, our guide to using a chimney starter explains how to get those first coals going without lighter fluid.
How Many Briquettes for How Many Hours?
Burn rates depend on the briquette brand, the weather and how tightly you pack the line, so treat these as starting points and write down what your own kettle does.
| Planned cook | Layout | Rough count |
|---|---|---|
| 3 to 5 hours (pork tenderloin, chicken pieces) | 2 rows, one third of the ring | About 40 to 50 |
| 5 to 8 hours (ribs, small pork butt) | 2 rows, half the ring | About 60 to 80 |
| 8 to 12 hours (pork butt, brisket flat) | 2 rows plus 1 on top, half to two thirds of the ring | About 90 to 120 |
Briquettes suit the snake better than lump. They are uniform, so the burn moves at a predictable speed. Lump varies in size and burns hotter. Our comparison of briquettes and lump charcoal covers the trade-offs.
Dialling In the Vents
Weber’s guide suggests aiming for 225 to 275°F at grill level, then closing the top vent halfway once you are in range. Position the top vent over the food, on the opposite side from the lit end, so smoke is drawn across the meat before it leaves.
- Bottom vent: start fully open, then close it in small steps if the temperature overshoots.
- Top vent: keep it at least a quarter open at all times so smoke can escape. A closed top vent stalls the fire and makes acrid smoke.
- Measure at the grate. Weber warns the lid thermometer can mislead. A probe clipped to the cooking grate beside the meat gives the real number.
Our deeper guide to charcoal temperature control explains why the bottom vent acts like a throttle and the top like an exhaust.
Snake Problems and Fixes
It runs too hot
Too many lit coals at the start, or the lid opened too often. Close the bottom vent by a quarter, wait 15 minutes, then adjust again. Next time, start with 6 to 8 lit briquettes instead of 10.
It goes out halfway round
A gap in the line, a wet section of coals, or choked vents. Push the coals back together with tongs and make sure the bottom vent is clear of ash.
Temperature drops in the late afternoon
The water pan has run dry or the wind has picked up. Weber suggests refilling the pan after about 3 to 4 hours. Shield the kettle from wind and open the top vent wider.
The meat tastes bitter
Too much wood or a smothered fire producing thick white smoke. Use fewer chunks and keep the top vent open.
Food Safety on Long Kettle Cooks
USDA’s Smoking Meat and Poultry fact sheet recommends keeping the cooker between 225 and 300°F throughout, using a food thermometer for the meat and a second thermometer for the air, and refrigerating leftovers within 2 hours. The snake makes holding that range far easier than a single heap of coals.
If beef is your next long cook, this guide to smoking beef on a kettle without a dedicated smoker explains which cuts suit the method.
Frequently Asked Questions
What is the difference between the snake and the Minion method?
Both rely on lit coals slowly lighting unlit ones. The Minion method puts a heap of unlit charcoal in a basket or ring and pours lit coals on top, so the fire spreads downward. The snake spreads sideways along a line around the kettle wall. On a kettle, the snake leaves more room in the centre for a water pan and food.
Can I add more briquettes to a snake mid-cook?
Yes. Lift the grate on the hinged side, or slide unlit briquettes onto the far end of the snake through the gap. Add them ahead of the burning section, not on top of it, so they light in turn. Refuelling is rarely needed if the snake was long enough to begin with.
Does the snake method work on a 26-inch kettle?
Yes. A bigger kettle has a longer circumference, so the same briquette count covers less of the ring and you can build a longer snake. Larger kettles also hold more air, which can make the first hour run hotter. Start with fewer lit coals and watch the grate temperature closely.
Do I need a water pan?
It helps. The pan adds thermal mass that steadies the temperature and catches drips that would otherwise burn on the charcoal grate. Weber’s setup includes one. If you want crisp poultry skin, leave it out and run the snake a little hotter instead.