---
title: "How to Season a New Smoker Before the First Cook – Grill50 — Practical Grilling & BBQ Guides"
description: "How to season a new smoker: oil and a low wood fire for raw steel offsets, the burn-in for pellet grills, and why enamelled bullets can skip it."
---

# How to Season a New Smoker Before the First Cook

[Cleaning &amp; Maintenance](https://grill50.com/category/cleaning-maintenance/)

To season a new smoker, you run it empty and hot for an hour or more before the first cook. That burns off the oils and residues left from manufacturing, and on raw steel smokers it builds a protective layer, much like seasoning a cast iron pan. How you do it depends on what the smoker is made of. Raw steel offsets need a coat of cooking oil and a long, smoky fire. Pellet grills follow a short burn-in set out by the maker. Porcelain-enamelled bullet smokers do not strictly need seasoning at all. Below: the steps for each type, which oil to use, and how to tell when it is done.

## What Seasoning Actually Does

- **Burns off manufacturing residue.** Traeger’s guide to [seasoning and burning in a grill](https://www.traeger.com/learn/how-to-season-burn-in-grill) describes these as residual, non-toxic oils from the manufacturing process. You do not want their smoke on your first brisket.
- **Protects raw steel from rust.** A baked-on layer of oil and smoke seals the surface.
- **Lets you learn the cooker.** A first run without food shows you how fast it heats, where the hot spots are and how the vents or controller respond.

Expect some dark smoke and odd smells at the start. That is the residue burning away, and it is the reason you do it without food.

## Step One for Every Smoker: Read the Manual

Makers give different instructions, and some are specific about what not to do: one model may say do not wipe off a factory coating before the first burn, another may say do not oil the exterior paint. The manual for your model overrides general advice, including this page. Check it before you start.

Then, before lighting anything:

1. Remove all packaging, stickers, cable ties and protective film, inside and out.
2. Wash the cooking grates in warm, soapy water, rinse and dry them.
3. Wipe the inside of the cook chamber with a damp cloth to remove dust and metal shavings.
4. Check that the smoker is assembled correctly, especially gaskets, the grease path and any baffles.

## Seasoning by Smoker Type

| Smoker type | Oil the inside? | Burn |
|---|---|---|
| Raw steel offset | Yes, a light coat in the cooking chamber | Low, smoky wood fire for a few hours |
| Pellet grill | Follow the manual (usually no) | Set routine: about 1 to 1.5 hours |
| Porcelain-enamelled bullet | No | Optional practice run |
| Kamado (ceramic) | No | A gentle first fire; follow the maker’s limits |
| Electric cabinet | Usually no; check the manual | Empty run with wood chips as the maker directs |

### Raw steel offset smokers

Oklahoma Joe’s [seasoning advice](https://www.oklahomajoes.com/pro-tips) is a good model for this type. Its tips say to spray a light coat of vegetable oil, cooking spray or peanut oil on the inside of the horizontal cooking chamber, then burn a very low, smouldering fire of wood logs or chunks in the firebox for a few hours. It is seasoned when the inside has a shiny black coating.

1. Apply a thin, even coat of oil to the inside walls, lid and grates. Wipe off any drips or pools; thick oil turns sticky.
2. Light a modest fire and bring the chamber up gradually.
3. Feed wood to keep it smoky and steady for a few hours.
4. Let it cool with the lid closed, then check for that dark, even sheen.

### Pellet grills

Traeger’s burn-in for its connected grills is a good example of how pellet makers handle it: run at 350°F for 20 minutes once it reaches temperature, then at 450 to 500°F for another 30 minutes, then shut down. Its non-connected models follow a slightly different routine of about an hour, starting on the Smoke setting. Other brands publish their own versions. Our guide to [pellet grill startup and common faults](https://grill50.com/pellet-grill-basics/) helps if the first ignition does not catch.

### Porcelain-enamelled bullet smokers

Enamel does not rust in the way raw steel does, so oil seasoning is not needed. The fan site Virtual Weber Bullet explains [why the Weber Smokey Mountain does not need seasoning](https://www.virtualweberbullet.com/seasoning-new-weber-bullet), and suggests an empty practice run to learn how the vents control temperature. It also notes that a new cooker’s shiny interior may run a little hotter at first, until a coating of smoke builds up.

## Which Oil to Use (and How Much)

Choose a neutral oil that handles heat: vegetable, canola, peanut or a cooking spray. Avoid butter, olive oil with a low smoke point, and flavoured oils, which burn unevenly and can turn rancid.

**The amount matters more than the type.** A thin film you can barely see is right. If you can see drips or pooling, wipe it back with paper towel. Too much oil turns into a sticky, gummy layer instead of a hard coat.

## How to Tell It Worked

- **Raw steel:** an even, dark, slightly glossy finish inside. Sticky patches mean too much oil; run another hot fire to cure them.
- **Pellet grill:** the smoke has cleared to thin and light, and the factory smell is gone.
- **All types:** you know roughly how long it takes to reach 250°F and how it holds there.

Your first real cook will finish the job. Fatty meat adds to the seasoning. Something forgiving and cheap makes sense here; GirlBeef’s list of [cheap beef cuts worth smoking](https://girlbeef.com/cheap-cuts-to-smoke/) gives good options that will not hurt if your first fire management is rough.

## Keeping the Seasoning Once You Have It

- Scrape grates after cooking, while warm. Oklahoma Joe’s tips suggest keeping water off the grates, then drying and oiling them to stop rust.
- Empty ash after each cook; wet ash holds moisture against steel.
- Keep it covered, and re-oil any spot that shows rust after sanding it lightly.
- Run another empty burn after fitting new internal parts, so any factory coating burns off before food goes in.

For grate care by material, see our guide to [cleaning cast iron, stainless and porcelain grates](https://grill50.com/how-to-clean-grill-grates-cast-iron-stainless-and-porcelain/).

## Frequently Asked Questions

### Do I really need to season a new smoker?

For raw steel smokers, yes: it burns off manufacturing residue and protects the steel from rust. For pellet grills, makers include a burn-in in the setup instructions, so follow it. Porcelain-enamelled smokers do not need oil seasoning, though an empty first run is still a smart way to learn the controls.

### How long does it take to season a smoker?

A pellet grill burn-in is usually about 1 to 1.5 hours, depending on the model. A raw steel offset typically needs a low, smoky fire for a few hours, plus cooling time. Plan it for a dry day when you are home, not the morning of your first big cook.

### Can I cook food the first time I season my smoker?

It is better not to. The first burn releases manufacturing residue and smells that you do not want on food. Run it empty, let it cool and check the finish. The second fire is the right time for food, and a fatty, inexpensive cut helps finish the seasoning.

### Should I season the outside of my smoker?

Usually not. Most smokers have heat-resistant paint on the outside that is not meant to be oiled. Some makers describe curing the paint with the first fire, but check your manual: oiling painted surfaces can leave them sticky and attract dirt.

### Recently Published

- [Baked Potato on the Grill: Foil or Bare, and How Long](https://grill50.com/baked-potato-on-the-grill/)
- [Smoked Bologna: How to Smoke a Whole Chub on Any Grill](https://grill50.com/smoked-bologna/)
- [Smoked Turkey Gravy From Drip Pan Drippings That Taste Right](https://grill50.com/smoked-turkey-gravy/)
- [Snake Method on a Weber Kettle: Layout, Count and Burn Time](https://grill50.com/snake-method-weber-kettle/)
- [How to Season a Blackstone Griddle the First Time](https://grill50.com/how-to-season-a-blackstone-griddle/)
- [Rubbery Chicken Skin on the Smoker? Fix It Five Ways](https://grill50.com/rubbery-chicken-skin-smoker/)
- [How to Carve a Smoked Turkey Without Shredding the Breast](https://grill50.com/how-to-carve-a-smoked-turkey/)
- [Can You Grill in the Rain? Safe Setups and What Changes](https://grill50.com/can-you-grill-in-the-rain/)
- [Griddle vs Grill: What Each Cooks Better Outdoors](https://grill50.com/griddle-vs-grill/)
- [Cold Smoked Cheese: Keep It Under 90°F and Let It Mellow](https://grill50.com/cold-smoked-cheese/)
- [Picanha on the Grill: Steaks, Skewers or Whole Cap](https://grill50.com/picanha-on-the-grill/)
- [What Size Grill Do I Need? Cooking Area by Household Size](https://grill50.com/what-size-grill-do-i-need/)
- [How to Smoke Beef Ribs: Plate, Chuck and Back Ribs Compared](https://grill50.com/how-to-smoke-beef-ribs/)
- [Smoked Beef Jerky: Lean Cuts, Safe Heating and Drying Cues](https://grill50.com/smoked-beef-jerky/)
- [Grilled Portobello Mushrooms: Meaty Caps, Not Soggy Ones](https://grill50.com/grilled-portobello-mushrooms/)

### Topics

- [BBQ](https://grill50.com/category/bbq/) (7)
- [Charcoal Grills](https://grill50.com/category/charcoal-grills/) (9)
- [Cleaning &amp; Maintenance](https://grill50.com/category/cleaning-maintenance/) (7)
- [Gas Grills](https://grill50.com/category/gas-grills/) (5)
- [Grilling Basics](https://grill50.com/category/grilling-basics/) (13)
- [Meat &amp; Poultry](https://grill50.com/category/meat-poultry/) (18)
- [Recipes](https://grill50.com/category/recipes/) (20)
- [Tools &amp; Equipment](https://grill50.com/category/tools-equipment/) (11)
- [Troubleshooting](https://grill50.com/category/troubleshooting/) (4)
- [Uncategorized](https://grill50.com/category/uncategorized/) (32)
- [Vegetables](https://grill50.com/category/vegetables/) (2)
